ISSN 1301 - 0883 | E-ISSN: 1309-3886
Color, whiteness, and surface roughness changes of group-shade and single-shade composite resins during a şalgam-induced staining and bleaching cycle: a longitudinal in vitro study [Eastern J Med]
Eastern J Med. 2026; 31(4): 879-891 | DOI: 10.5505/ejm.2026.32698

Color, whiteness, and surface roughness changes of group-shade and single-shade composite resins during a şalgam-induced staining and bleaching cycle: a longitudinal in vitro study

İkbal Esra Pehlivan1, SEMA KAYA2
1Department Of Restorative Dentistry, Faculty Of Dentistry, Van Yuzuncu Yil University, Van, Turkey
2Department Of Oral And Maxillofacial Radiology, Faculty Of Dentistry, Van Yuzuncu Yil University, Van, Turkey

INTRODUCTION: Resin composites may undergo discoloration and surface degradation after exposure to acidic pigmented beverages, while bleaching may further affect their properties. This study evaluated color difference (ΔE₀₀), whiteness index (WIᴅ), and surface roughness (Ra) of conventional, group-shade, and single-shade composites during a şalgam-induced staining and bleaching cycle.
METHODS: Disk-shaped specimens (8 × 2 mm) were prepared from five resin composites (n = 10/group). Measurements were performed at baseline (T1), after 24 h (T2) and 1 month (T3) of şalgam immersion, and 1 day (T4) and 10 days (T5) after bleaching with 35% hydrogen peroxide. ΔE₀₀ and WIᴅ were determined spectrophotometrically and Ra using a contact profilometer. WIᴅ changes were analyzed using Friedman tests, between-material differences using Kruskal–Wallis and Dunn–Bonferroni tests, and material-by-time interactions using rank-based permutation tests.
RESULTS: Significant material-by-time interactions were detected for ΔE₀₀ and WIᴅ (both p < 0.001) and Ra (p = 0.049). At T3, Essentia Universal (S1) showed the greatest discoloration (ΔE₀₀ = 11.47 ± 2.75), whereas OptiShade (G2) showed the lowest (3.39 ± 0.25). After bleaching, Filtek Easy Match (G1) showed the greatest whitening recovery (82%), while S1 showed the lowest (−21%). Surface roughness increased after staining, particularly in S1, and decreased after bleaching.
DISCUSSION AND CONCLUSION: The tested composites showed material-dependent variability in color stability, whiteness recovery, and surface roughness. Group-shade composites showed more consistent overall performance, whereas single-shade composites showed greater variability. Material selection should consider long-term esthetic behavior in addition to initial shade matching.

Keywords: Single-Shade Composite, Group-Shade Composite, Tooth Bleaching


Corresponding Author: İkbal Esra Pehlivan, Türkiye
Manuscript Language: English
×
APA
NLM
AMA
MLA
Chicago
Copied!
CITE
LookUs & Online Makale